Piñata Inks Polymer Clay Earrings and Transfer Sheet

Make yourself a great gem with transfer sheets by Lisa Pavelka thanks to Lois's jewelry .

Step 1 :
Spread the white Fimo dough with the doughmachine and place a sheet of metal (of your choice) on it.

2nd step :
Sprinkle the support of Pi ata ñ inks by drops, the color of your choice, here Sun Yellow , Tangerine , and Chili Pepper .
Leave to air dry a few minutes, then if there are empty holes add a few drops of ink.

Step 3:
Spread a thin transparent Premo dough sheet. Place it over the colored plate you just made with the inks. This layer of dough will serve as protection.

Step 4:
Put everything in the machine, it makes crack the sheet of metal. Do this on one side and then on the other.


Step 5:
Choose a pattern you like from our different transfer sheets .

Step 6:
Cut out your pattern and moisten it with a few drops of water.

Step 7:
Wait about 30 seconds to gently slide the pattern off the sheet, as shown below. If you can not, wait a few more minutes.

Step 8:
Gently lay the pattern on your colored polymer plate. Press lightly with your finger to adhere the pattern to the polymer clay, it also removes air bubbles.

Step 9:
Using the cookie cutter of your choice, draw and detach your shape. Make a hole at the end of your shape to be able to pass a ring.

Step 10:
Cover all your pieces with liquid Fimo to better preserve the patterns. The gel shrinks when cooking, so be generous on the amount.

Step 11:
Bake your pieces in the oven at about 110 ° C for 20 minutes.
To increase transparency, put your creations in cold water right after you take them out of the oven.

Step 12:
Show off your creation.
Open your open ring and insert your pearl and stud .
Close the ring and do the same for the second loop

You can also make a necklace: (think to make a hole, before the cooking of your pieces, adapted to your creation)