Tape the first three holes on the back of the ring.
Prepare the resin. Add the colorant. Mix well.
Video - DIY multicolor ring in UV LED resin
How do I put resin inside a ring?
UV LED resin catalyzes or cures under UV LED light in a matter of minutes or even seconds. This is a big advantage over two-component epoxy resin, which generally takes 48 hours to catalyze. This makes it possible to carry out certain projects that would be impossible with epoxy resin. However, it is a resin that shrinks more than epoxy resin and should only be used in thin coats. This makes it perfect for jewelry-making. To use this resin, you need a UV LED lamp. You'll find one at the bottom of the page in the equipment list. A lamp for semi-permanent nail polish will also do the trick.
Here are a few recommendations:
- Ventilate your room or wear an organic vapor mask.
- Wear gloves and safety goggles.
- Keep everything out of the way while handling the product.
- Do not do this directly on your table: use a silicone mat to which the resin will not adhere. Resin is impossible to remove from porous surfaces.
- Make sure you have a usb charger, as the lamp is supplied without one. There is only one cable in the box.
- Don't make your jewelry in direct sunlight or with too much light in the room, as the resin may begin to catalyze.
- Have all the materials ready in advance so you don't have to stop during the process.
- Equipment: protective equipment, silicone mats, fine stirrers, mixing cups or jars, covers to protect mixes from light, uv led lamp, lighter or gas-lighter (to make air bubbles in the resin disappear).the air bubbles in the resin), colorants, ring, scotch tape, paper towel, small garbage can bag in a bowl to avoid putting the paper towel with the resin on the table. The scotch tape will serve as a support for placing the resin in the holes of the ring.
- Thin spatulas have been added to the equipment list, as the spatulas in the glove resin kit are very wide. Clean these spatulas with paper towel and rubbing alcohol before the resin hardens on them.
In the materials list, in the variation section, we've included shading cases. These are boxes in which you can mix colored resin. They have a cap to protect the mixture from light, and labels to show the color of the resin inside. With this type of device, you can keep your resin for 1 week without it hardening. They must be used with Padico cups. The cups can be cleaned with rubbing alcohol before the resin hardens.
Adjust the ring to your size before applying the resin. Do not change the ring size once the resin has been applied, as it will come off.
Tutorial steps
Use a thin spatula or toothpick to place the resin on the scotch tape. Apply a thin layer, trying not to extend too far over the edges.
To eliminate small bubbles, you can use a gas-lighter or lighter.
Place the ring under a UV resin lamp. Be careful when placing the ring, as the resin will fall off until it is cured (catalyzed).
Wait 1 minute. As the layer is thin, the resin hardens fairly quickly.
Move on to the next hole and proceed in the same way.
Remove the tape. To make it transparent again, apply another layer of resin to the back.
Continue until the entire ring is covered.



You have a question about this tutorial? Ask it to our team and the people who have already tested it. The Perles & Co community is here to help you!
Credits
Perles & Co, Internet & E-Commerce company [26/11/2023] Any reproduction, representation, adaptation, in any form whatsoever, even partial, is prohibited, except for reproduction for private use not intended for collective use, representation in the family circle (art. L 122-5 CPI) and online publishing on condition that the source is mentioned and a link is included to the corresponding page of our site www.perlesandco.com.











