Flower and drop earrings mix of resin and polymer techniques

Do you know how to use UV resin ? Create with this tutorial earrings resin and polymer clay. Cernit Opaline paste is used to make the flowers using a mold and then small pieces of cooked pasta are included in the resin drop.

Step 1

Take small amounts of pasta, pass them in the dough machine a notch between the middle and the end.

2nd step

Randomly put small pieces of gold leaf on the different pasta plates. Roll the roll to adhere the sheet to the polymer.

Step 3

Make thin strips by cutting with a blade in the pasta plates then continue to cut the lengths to obtain very small chopsticks. Book.

Step 4

Take in each color used another small amount of dough in the form of a ball. Put your dough on the hibiscus flower mold (the other flower on the same mold is a rose), press hard then with your blade being very careful not to cut the silicone remove the excess dough. Make 2 flowers for your pair of curls.

Step 5

Place a small piece of gold leaf in the center of the flowers and adhere the metal to the paste by brushing the end of a brush on this surface. Start cooking all your flower and stick pieces in a traditional oven at 120 degrees for 30 minutes.

Step 6

Once your flowers come out of the oven you can iron with a brush on the center to remove excess metal foil.

Step 7

Put some resin in the drop-shaped transparent mold. Place some Fimo sticks on the resin then pass the mold under the UV Led lamp to catalyze your resin by pressing once on the switch. Fill the mold completely with UV resin by adding other pieces of pasta. Catalyze a second time. Make 2 drops for a pair of earrings. You can if you want to put a layer of resin on the face in view to round off all the angles and thus obtain a smoother surface by catalyzing of course afterwards.

Step 8

Drill with your drill Dremel or a hand mandrel all your resin drops.

Step 9

Place a ring inside each hole and close the ring after passing inside the ring of the nail.

Step 10

Place strong glue on the ear disc then apply the corresponding flower strongly on it. Wait 2 hours and then drop on the same back of the ear a large drop of resin that you will spread the metal to the edges of the polymer clay flowers.Repeat your parts under the lamp.