Average Grades
Put a drop of glue inside the tip.
Free shipping on orders over 50€ up to 500g
French Online shop for beads and accessories for the creation of DIY jewellery and other creative hobbies
Log-in
0
Shopping cart
Shopping cart
Instructions to mount properly a cord terminator.
Material and advice:
You will need a cord, we have used a leather cord 4mm Natural.
A cord terminator, of same diameter than the cord, we have used in the example below a terminator for 4mm cord Bronze tone.
Glue, here we have used Hasufix glue.
Step 1:
Spill a drop of glue into the terminator.
Step 2:
Place the cord inside the terminator.
Step 3 :
Let dry for a few minutes and that's done.
If you use fraying threads, such as cotton waxed or rattail cord, just add some glue at the end of the thread.
This way it will be easier for you to enter the thread into the terminator.
Put a drop of glue inside the tip.
Place the cord in the tip.
If you are using a cord that tapers, such as waxed cotton or rat tail, put a little glue on the end of the cord.
This will make it easier and neater to get the cord into the tip.
Let dry for a few minutes and you're done.
Credits
Perles & Co, Internet & E-Commerce company [07/10/2015] Any reproduction, representation, adaptation, in any form whatsoever, even partial, is prohibited, except for reproduction for private use not intended for collective use, representation in the family circle (art. L 122-5 CPI) and online publishing on condition that the source is mentioned and a link is included to the corresponding page of our site www.perlesandco.com.
