DIY bracelet with Star Beads glass beads, Arcos®, Miniduo and PureCrystal crystals

How to make a DIY bracelet with glass beads?

How to make a bracelet with the new Star Beads glass beads?

Are you waiting for them? The new pearls of glass of Pearls and Co are finally out. Star-shaped and with its 4 holes you can associate with your wishes Rocailles beads, PureCrystal crystals ... Discover the tutorial Pilar Andés alias Bisaneta , who offers to make a sublime bracelet with glass beads Star Beads , Arcos ® , Miniduo and PureCrystal crystal tops .

Are you new to jewelery creation? Do not hesitate to consult in our toolbox to learn the basics of jewelry creation .

Thanks to Pilar for sharing his tutorial.

Before you begin, here are the abbreviations used in the diagram:

• Toho Rockery: R
• Rockery Miyuki duracoat: R1
• Rockery Miyuki 15/0: R2

Step 1: Cut a little over a meter of thread by threading a needle at each end. Thread 1 R, 4 R1, 3 R, 4 R1 and 1 R. Bring all your beads to the center of the thread.

Step 2: Slide your clasp as shown in the picture.
Then start your creation by passing each needle through the hole of a Star Beads glass bead.

Step 3: Thread a pearl R2, then Arcos pearls.

Step 4: Then thread a R2 bead, a Star Beads glass bead and a r2 bead on each of the 2 threads.
Then add 3 pearls Arco as taught in the photo.

Step 5: Thread a R2 bead on each wire and then a Star Beads glass bead.
Now repeat the previous steps until the desired length is achieved.

Step 6: Then finish your bracelet by threading a Star Beads glass bead.
Immediately after, put the same number of seed beads as in step 1: 1R, 4 R1, 3 R, 4 R1 and 1 R. Then add the clasp as shown in the picture.
Then put your second thread in all the rockeries and tighten, pulling the 2 threads in the opposite direction.

Step 7: Now take one of the 2 sons. We will start by making one side of the bracelet. Take the thread emerging from the last rockery of step 6 (R), then put on 3 R1 and 1 R.
Then pass your thread through the Pearl Arcos, as taught in the photo.

Step 8: Thread R2 - Router - R2 and go through the next Arcos bead.

Step 9: Now put on a Pearl R2 - 1 Miniduo - 1 R2 and go through the adjacent Arcos Pearl.
Then pass your thread through the hole in the middle of the Arcos bead and then through the hole of the mini duet. Then bring out your thread through the hole in the middle of the adjacent Arcos beads as taught in the picture.

Step 10: Thread a pearl R2 then put on 3 R2 as taught in the photo. Then go through the pearl Arcos.

Step 11: Repeat the same operation for the full length of the bracelet.

Step 12: Thread a pearl 1 R and 3 R1 and pass the thread in all the rockeries of step 1.

With the remaining thread, repeat the previous 5 steps. Then check the 2 threads and finish your bracelet.

Your bracelet is now finished!

We love to see your creations, so do not hesitate to send us your photos on our Facebook page or to tag us on Instagram with #perlesandco !