Magnet guy in polymer clay

Step 1:
Take a quarter of a bar of red polymer clay, knead it into a ball.

Step 2:
Flatten the ball with a roller or pass it through the thickest notch on the machine.

Step 3:
Place cling film over the clay and cut out heart-shaped pieces with the heart-shapedcutter.

Step 4:
Bake the heart for 15 minutes at 110 degrees.

Step 5:
Take 1-2 bars of black polymer clay and shape into a cylinder.

Step 6:
Remove a little clay from the cylinder to form the head. Refine the ends of the cylinder by rolling it on a support while pressing on the ends.

Step 7:
Cut your man lengthwise with a blade without touching the center.

Step 8:
Round off the limbs and spread the arms wide to make room for the head.

Step 9 :
Roll over the body to flatten it.

Step 10:
Place the head and press down firmly.

Step 11:
Lift your man from his stand and press on the sides to refine the size.

Step 12 :
Bake for 30 min at 110 degrees.

Step 13:
Detach the head, then sand your parts in soapy water with abrasive sponges. Finally, wipe with a soft cloth.

Step 14:
Varnish the heart with the finishing lacquer.

Step 15:
Glue the head to the body and the magnet to the back. Leave to dry thoroughly.