Cut 1.5 m of thread and thread a needle on each end of the thread. Weave the row of beads shown in the diagram. For a more detailed explanation of Brick Stitch weaving see the tutorial in the introduction. Place the beads in the center of the thread.

How to make a crane pin in miyuki?
Miyuki weaving kit limited edition cherry blossom in 2018.
Brick Stitch technique. Refer to the sheet on Brick Stitch and this: /tutoriels/t9841-diy-coquillages-conque-en-perles-miyuki-tissage-brick-stitch.html
Link to the cherry tree brooches from the week before => indicate similarity of beads. Just need to add the turquoise beads.
Tutorial steps
Remove one of the two needles and begin weaving the left or right side of the crane, increasing or decreasing as necessary.
Stitch the pike to the weave then wedge the thread into the weave and cut it. You can stiffen the weave by applying glue to the back of the pin.



You have a question about this tutorial? Ask it to our team and the people who have already tested it. The Perles & Co community is here to help you!
Credits
Perles & Co, Internet & E-Commerce company [27/06/2023] Any reproduction, representation, adaptation, in any form whatsoever, even partial, is prohibited, except for reproduction for private use not intended for collective use, representation in the family circle (art. L 122-5 CPI) and online publishing on condition that the source is mentioned and a link is included to the corresponding page of our site www.perlesandco.com.











