Turquoise blue ceramic tube beads necklace

Cut 52 cm of wire. Thread a squeeze bead and a wire protector over it. Push the end of the wire back through the squeeze bead. Bring the two ends of the wire guard together by pinching them with your fingers. Extend the end of the wire about 5-6 cm beyond the bead.

Squeeze and pull the bead closer to the wire guard. Flatten the bead with a crush bead pliers which will make a fold in the middle of the bead. Then bend the bead in half with the second end of the pliers and finish by squeezing it a little more with the flat end of the pliers.

Check that the wire is not slipping anymore and continue to the next step.

Place a crushable bead cover over the crushable bead for a nicer finish. Next, thread 10 glass beads. Both ends of the wire must go through the beads.

Thread one irregular golden bead 5 mm, 10 glass beads, 1 golden bead, 1 white ceramic square, 1 golden bead5 mm, 5 glass beads, 1 gold bead, 1 blue glazed ceramic tube, 1 gold bead, 3 glass beads, 1 gold flower disc, 1 white ceramic square 1 white ceramic square, 1 golden roundel, 3 glass beads, 1 golden flower roundel, 1 blue ceramic tube, 1 golden roundel, 1 white square 1 white square, 1 golden washer, 1 white square, 1 golden washer, 1 white square, 4 golden washers, 1 blue ceramic tube for the middle bead.

Then do the reverse to make a symmetrical necklace.

At the end, thread a crush bead and a wire guard. Repeat step 1 but remember to thread the remaining wire end through the beads and tighten the necklace a bit before crushing the bead. Once the finishing touches are made and the bead cover is placed on the necklace, cut off the excess wire.

Add a 5mm open ring on each wire guard with two jewelry clips, then, a 9mm ring on one side and a spring clasp on the other. Your necklace is finished.