The transfer of images on Fimo paste, and other polymer pastes, can transfer a design to customize your creations fimo.
We suggest you discover in this sheet one of the methods that allows to make transfers on polymer clay.
Beware, the image will be printed in negative, ie it will be reproduced in reverse compared to the design that you used. Remember to turn your design over before applying it if you want it to be in the right place.
Cut out the pattern.
Place the image on the polymer clay (the printed side must be in contact with the clay).
Lightly press the image with your finger so that it adheres well to the polymer clay.
Soak the cotton swab in acetone and run it over the back of the image.
Repeat the acetone several times until the image is transparent.
Be careful to only soak the design and not to soak it so that the ink does not smudge.
Gently remove the image. Wait a few moments for the ink to dry.
Your transfer is done, you can now put the dough in the oven.
The transfer does not change the baking time and temperature.
Credits
Perles & Co, Internet & E-Commerce company [04/03/2021] Any reproduction, representation, adaptation, in any form whatsoever, even partial, is prohibited, except for reproduction for private use not intended for collective use, representation in the family circle (art. L 122-5 CPI) and online publishing on condition that the source is mentioned and a link is included to the corresponding page of our site www.perlesandco.com.
