Tuto fine bracelets with heishi beads and charms

Instruction for a wrist of 15.5 cm maximum: Cut 5 pieces of yarn of 20 cm.

On each thread, make a first knot at 3.5 cm from the end.

For the first strand: String 3 gold beads. Make a knot after the beads. You can use a needle or toothpick to "guide the knot" to the desired location. To do this, thread the needle through the loop of the pre-made knot and use it to move the knot.

Make a new knot 6 cm from the end. Thread 1 delica, 1 gold flower washer, 6 mm khaki heishi, 1 single gold washer, 1 neon pink heishi (collected from the multi-colored heishi thread), 1 single gold washer, 6 mm beige heishi, and then repeat the beginning in the opposite direction. Make a knot after the beads.

Make a new knot 1.5 cm further, about 10.5 cm from the end and string 3 gold beads. Make a final knot after the beads.

On the second piece of wire, string 1 delica, 1 flower washer, 13 gemstone tubes, 1 flower washer, 1 delica. Make a knot after the beads.

On the third thread, thread 1 delica, 1 flower ring, 1 cm of heishi kaki, 1 golden tube, 1 gemstone tube, 1 golden tube, 1 cm of heishi kaki, 1 golden bead. Put a ring on the charm and close it without leaving any opening. Put on the charm. Thanks to the ring, the charm will face the bracelet. Do the same thing in reverse and finish with a knot.

On the fourth thread, thread 1 delica, 1 flower puck, 7 mm beige heishi, 1 single gold puck, 1 fluorescent pink heishi, 1 gold puck. Repeat this sequence several times. In total there are 8 times 7 mm heishi. Tie a knot after the beads.

The fifth thread is a little more worked. Thread 5 delica, 1 golden bead, 3 delica, 1 golden bead, 1 flower roundel, about 3 mm beige heishi, 1 single golden bead, 3 mm kaki heishi, 1 golden beade, 1 round charm, 1 gold bead, 3 mm khaki heishi, 1 simple gold washer, 3 mm beige heishi, 1 gold bead, 1 pink charm on which you have attached a ring beforehand. After the charm, repeat the beads in symmetry. Make a knot at the end.

Put glue in the clamp with a toothpick. Place the first two pieces of wire on the side where the knot was made, 3.5 cm from the end. Press the threads firmly into the lace clip with the toothpick. Put a little glue back on top with the toothpick. Place the other 3 wires, still on the same side. Again a little glue. Wait 15 minutes for the glue to set. Then close the lace clip with a flat clip. Close it on both sides.

On the other side, line up the wires. Trim the wire ends to within 1 inch of the knot so they are all the same length. Repeat step 6 to glue them into the other lace clip.