how to make a necklace ?
Which thread to make a necklace? This is the eternal question, which comes up at the beginning of each creation, especially when you are a beginner. For this tutorial, I took a metallic wire because it will be more resistant to friction and it will better support the weight of gemstones. Don't forget to choose your wire according to the diameter of the holes of your beads.
Cut 2 pieces of wire of 40 cm. Thread a squeeze bead and then pass the wire through the closed ring and back through the squeeze bead. Using flat pliers, lock the wire by crushing the crush bead.
String the beads following the pattern on the picture. You need to alternate between the Amazonite beads, the gold round beads and the zircon round bead.
Insert a crush bead two beads before completing the first side of your necklace. Pass the wire through the ring of the Amazonite pendant, then back through the 2 beads and the crush bead. Tighten the assembly and crush with the flat pliers.
Do the same for the other side.
You have a question about this tutorial? Ask it to our team and the people who have already tested it. The Perles & Co community is here to help you!
Credits
Perles & Co, Internet & E-Commerce company [01/08/2022] Any reproduction, representation, adaptation, in any form whatsoever, even partial, is prohibited, except for reproduction for private use not intended for collective use, representation in the family circle (art. L 122-5 CPI) and online publishing on condition that the source is mentioned and a link is included to the corresponding page of our site www.perlesandco.com.
