You know the tenderness
Measure a length of chain so that you can choose between 3 or 4 turns of the finger on which you want to wear your ring. Leave a small margin so that you can roll the chain on when you put it on.
Place your sprocket for ball end chain. Insert one side first so that the chain engages in the sprocket and then the other side.
Prepare your different charms by inserting them on flat-headed nails.
Use round-nose pliers to form the buckle that will allow these charms to be attached to the ring.
Open your ring with pliers. Insert the charms on the ring and connect it to the ring.
You can of course decide to make this creation into a bracelet. All you have to do is adjust the length of the chain at the beginning of the tutorial.
You have a question about this tutorial? Ask it to our team and the people who have already tested it. The Perles & Co community is here to help you!
Credits
Perles & Co, Internet & E-Commerce company [23/11/2020] Any reproduction, representation, adaptation, in any form whatsoever, even partial, is prohibited, except for reproduction for private use not intended for collective use, representation in the family circle (art. L 122-5 CPI) and online publishing on condition that the source is mentioned and a link is included to the corresponding page of our site www.perlesandco.com.
