Hand-crafted jewelry has a unique charm, and making your own rush bracelet with natural stones is both fun and rewarding. In this tutorial, we've opted for rhodonite, a fine stone renowned for its delicate shades of pink and black. We've paired them with rose quartz charms to bring a touch of softness to the ensemble. You'll find a vast choice of gemstones, from which you can select those with a diameter of 3.5 mm to fit perfectly into the groove of the bead.
If you'd like to learn more about the properties and symbolism of Rhodonite, as well as other gemstones, don't hesitate to consult our gemstone guide.
This DIY tutorial has been designed to be simple and accessible to all, requiring only basic skills in using glue and stringing beads. So it's a perfect choice if you're a beginner in costume jewelry design.
By following this easy tutorial, creating a personalized bracelet with letters will take you very little time. Adding alphabet charms in italic or classic fonts will make your bracelet even more unique. The final piece of jewelry will have a personal meaning for you.
This golden bracelet is a proud addition to our "Automne Doré" collection of DIY jewelry, a line specially designed to highlight the beauty of gemstones. We invite you to take a look at our entire jewelry range right now!
Start by organizing your workspace, with all materials at hand. Using the beading needle, thread the beads onto the nylon thread. For every 10 beads, slip on a round charm. The total length of the thread should be 22 cm. Check as you go.
Once finished, tie a knot on each side so that the beads are perfectly aligned and touching.
Take your wedding band and make sure it is clean and free of any dirt or residue. This will ensure optimum glue adhesion. Position the precision tip on your jewelry glue. Then apply glue all along the bracelet.
Place the bracelet on a flat surface. Then carefully place your pearl strand in the hollow of the bracelet.
This step is quite delicate. Take your time to avoid getting glue all over the beads.
Once finished, tie a triple knot, then trim off excess thread ends.
Add a dot of safety glue to the knot. Leave to dry for 24 hours.
You have a question about this tutorial? Ask it to our team and the people who have already tested it. The Perles & Co community is here to help you!
Credits
Perles & Co, Internet & E-Commerce company [06/10/2023] Any reproduction, representation, adaptation, in any form whatsoever, even partial, is prohibited, except for reproduction for private use not intended for collective use, representation in the family circle (art. L 122-5 CPI) and online publishing on condition that the source is mentioned and a link is included to the corresponding page of our site www.perlesandco.com.
