DIY Cute bracelets easy to make

The example bracelet is 18 cm, which may be a bit large for a child. You will need to adjust the number of beads. The bracelet needs to be at least 1.5 cm larger than the wrist, so start by measuring the wrist of the person who will wear the bracelet.

The spacer is about 2 cm and the attachment system is 2.5 cm. So 2+2,5 = 4,5. The length of the sides of the bracelet should be (the size of the wrist + 1.5 cm) - 4.5 cm. Then divide this measurement by two. For example, for a 14.5 cm wrist: ((14.5+1.5)-4.5)/2 = (16-4.5)/2 = 11.5/2 = 5.75 cm. So, about 6 cm on each side of the spacer.

Cut 30 cm of nylon thread and thread it through the divider. Put the spacer in the center of the thread. Thread 1 quartz bead, 1 golden flower washer, 3 quartz beads, 1 golden flower washer on both ends of the thread at the same time and then thread 10 Miyuki beads separated by 1 golden flower washer several times.

Thread a squeeze bead. Thread the two wires through the closed ring and then through the crush bead again. Then thread the two wires through the quartz bead and washer and then through some Miyuki beads if possible. Tighten the wire and then crush the bead to be crushed. Check that the wire is fixed by pulling the ring. Then cut the excess wire.

Repeat step 2 to make the second side of the bracelet. Open the snap ring to attach it to the open ring.

The technique is the same with the second bracelet. We used a carabiner as a clasp, but you can take the same clasp as the previous model. The spacer and the closing system is a little smaller. The whole thing measures about 3 cm.

Start by stringing 1 quartz bead, 1 golden washer, 5 turquoise miyuki beads, 1 golden washer. Repeat the sequence until you have the right length.