Multi-row bee necklace silver-gold

Take your 4mm Gold Rope Chain and measure the length you want by wrapping it around your neck. Here we have used a length of 60 cm.

Cut the chain with a cutter, you will find here a technical sheet explaining how to do it.

You can find a technical sheet here explaining how to do this. Take your tips and your jewellery glue and just put a little glue at the bottom of the tip, insert the chain and leave it to set for at least 24 hours. (yes it's long and we know you want to wear it right away but everything comes to him who waits ;) )

You can now take your rhinestone chain and also cut the length you want, more or less choker! Here we took a length of 38 cm

Cut the chain with your cutter and you just have to put the last link in your rhinestone chain tip 2 mm and tighten the edges with a flat clip.

It does not remain any more than to come to put there small gold rings 4 mm (or silver plated!) of each side

Finally we start again for the silver jaseron chain, here we used a length of 44 cm

Thread your pendant and small rings of 4 mm at each end and you're done.

Take your 5 mm ring and you can thread your 3 necklaces through it. Do the same on the other side but with your clasp. You can now take your 7mm ring and attach it to your 5mm ring

Pay attention to the order in which you thread your necklaces into the 5mm ring so that they are in the right direction when you wear it :)

And that's it!