Trendy multi-row necklace with Carnelian and Unakite gemstones

Cut cm of wire. The total length of this part of the collar is . You can of course adjust the length.

Insert a squeeze bead and then pass your wire through the closed ring of the clasp and back through the squeeze bead. Crush your crush bead with flat tongs.

Thread 4 pearls tubes then 2 pearls golden round. In the center of the necklace, insert the mystical eye pendant. Then continue to thread the tube beads and golden washers.

Insert a bead to be crushed then pass your cable in the closed ring then pass again in the bead to be crushed. Crush your crush bead with flat tongs.

Thread the carnelian and gold beads following the pattern in the photo.
Integrate the mini diamond charms at cm

Finish the necklace with a pearl to crush

Cut a piece of silk cord of cm.

Glue the eye cabochon on the setting and add a ring

Fold the cord in half to place your cabochon in the centre. Make a knot on each side.

Make sure everything is symmetrical. Slide in the round beads then make a knot and then the cubic beads

There is a cm between the cubic beads and the round beads.

A little tip to make the beads go in easily, glue the end of your cord. It will be easier to slide the beads.

To finish your necklace, use the clasp with the lace clips. Place a dot of glue in the lace clip then position the cord and close with a flat clip.