Start by taking the length of chain you want to make your necklace. It can be worn as a choker or a necklace. Cut the desired length with a pair of wire cutters.
Using your Hasulith jewellery glue, apply a little glue to the ends of the chain so that you can insert it into the string ends.Let it dry for about 1 hour before handling your chain again.
Once the glue has dried and your tips are securely attached, open the ring on your clasp with two jewelry pliers to connect it to one of the two tips.
Thread the end of your silver wire through the hole in your bead. Using your jewellery pliers, form a loop large enough to be able to insert the end of your chain and vary your pendants. Once the loop is formed, wrap the silver wire around itself to lock it in place.
With the wire remaining under the bead, make several turns around it, in the width or length of the stone according to your wishes. Block the remaining wire inside the hole of the bead if this one allows it (the holes of the stones have a variable diameter) by depositing a very small point of glue on it beforehand or twist it around another wire and cut it. Your pendant is ready to be threaded on your chain.
You have a question about this tutorial? Ask it to our team and the people who have already tested it. The Perles & Co community is here to help you!
Credits
Perles & Co, Internet & E-Commerce company [29/12/2020] Any reproduction, representation, adaptation, in any form whatsoever, even partial, is prohibited, except for reproduction for private use not intended for collective use, representation in the family circle (art. L 122-5 CPI) and online publishing on condition that the source is mentioned and a link is included to the corresponding page of our site www.perlesandco.com.
