Peyote weaving grid, forget-me-not pendant in Miyuki Delicas 11/0

How to weave a forget-me-not flower in Miyuki Delicas 11/0?

Today Hello is Marine offers a nice forget-me-not pendant woven in peyote but notice to fans of Brick Stitch, it is quite possible too!

Find his universe also on his Instagram account .

Here is a list of tutorials which will be useful for the realization of this Myosotis pendant:

• How to make a simple pair Peyote weaving?
• How to increase and decrease in peyote?
• How to open a ring to make a jewel?

Caption:
A: DB-0322
B: DB-0351
C: DB-0881
D: DB-1497
E: DB-1587
F: DB-1597
G: DB-2284

Step 1: Take a meter of wire.
To weave this diagram in peyote, you must start by determining the 2 longest rows:

Then, they must be mounted this way, in the middle of the meter of wire:

Step 2: With one of the threads, weave the bottom of the forget-me-not, increase and decrease to follow the diagram. Tuck your thread in several rows, cut flush with precision scissors.

Step 3: With the thread left aside previously, now weave the top of the forget-me-not. Increase and decrease so you can follow the diagram.

Only the highest pearl remains to be placed, but first put the ring of the pendant on it:

Step 4:
Use the thinnest ring (the 0.5mm ones) to make sure it goes through the hole in the Miyuki bead.
Open your ring using two pliers.
Thread your pearl, and close the ring.

It is now necessary to pass your pearl provided with its ring, on the thread of your weaving.
To do this, you must remove your needle and pass the thread alone through the pearl (if you leave the needle, it will not be able to pass through the pearl, because of the volume of the ring already present).

Put your needle back, place this last pearl, then tuck your thread in several rows, and cut it short.

Step 5:
Your pendant is now finished. You need to cut a piece of chain, to the desired length. At one end of this chain, attach a ring (one of the thickest), to do this open it with two pliers, slide the chain into it, and close it. At the other end, and still using the pliers, place the clasp.
Finally, place a thick ring in the middle of the chain: open it with pliers, slide the chain into it, and the small ring on your forget-me-not pendant.
Your pendant is now attached to its chain, your necklace is finished!