DIY Menton dangle earrings with seed beads and knots

How to make dangling seed bead earrings?

How to make hanging earrings in seed beads and knots?

Today, we are offering a new tutorial to make pretty dangling earrings in seed beads and knots. Many thanks to Du filet des perles for sharing his technique. Don't hesitate to take a look at his Facebook page .

In order to create a pair of earrings that looks like you, do not hesitate to choose other colors of seed beads 11/0.

For fans of this style of jewelry, here are the other tutorials from Wire and Pearls:

Silver and gold dangling earrings in pearl weaving

Aztec dangle earrings with seed beads

The stages :

Step 1: In the spool of white wire, cut 6 wires of 20 cm each. Fold them in half and tie them one by one on the 12 mm gold ring by making a lark's head knot.

Step 2 : Take 20 cm of yellow thread and start the first row by knotting the yellow thread on each of the white threads as follows:

Repeat the above operation on all the white wires. Attention: before starting each knot, make sure that the yellow thread is always below the white thread. Tighten your work well. You get this:

Burn the end of each white wire, stretch between your fingers and cut in a bevel to form a point so that you can thread a gold seed on each wire:

Step 3 : Return your work. Cut 22 cm of white wire, thread on it 11 black half round seed beads. Make the second row, in the same way as the first, but inserting a rock garden between each series of knots:

Step 4 : Put the work on the right side. Cut 24 cm of black wire, thread 10 blue seed beads on it. Make the third row and last row, in the same way as the previous ones, by inserting a rock garden between each series of knots except in the middle, which you will leave empty so that you can hang the charm:

Step 5 : Thread a white rockery on each of the white threads. Cut the excess leaving a small piece of wire that you will burn to stop the work:

Cut the wires on each side, burn them, you get this (front and back):

Step 6 : Open a 5x0.7 mm golden steel ring, slide it in the middle of the fan, in the space left free, put the epoxy shuttle on it and close. Finally, attach the gold filled ear hook.

Here, your pair of earrings is finally finished! So, do you like it?

Do not hesitate to share the result of your creations on our social networks: our Facebook page and our Instagram page