Make pretty DIY costume jewelry with these clamp-on ends. They hold ribbons, chains, fabric, bias... in place.
Place one end of the bias tape between the claws of the clamp.
For a better hold, bend the end of the bias about 0.5 mm.
Center the end cap to be tightened, so that the bias does not protrude from it.
Place the nylon-tipped pliers in the center of the tip to be tightened, and tighten.
Then tighten on the edges of the fitting to be clamped.
Here's the result!!!
Credits
Perles & Co, Internet & E-Commerce company [07/10/2015] Any reproduction, representation, adaptation, in any form whatsoever, even partial, is prohibited, except for reproduction for private use not intended for collective use, representation in the family circle (art. L 122-5 CPI) and online publishing on condition that the source is mentioned and a link is included to the corresponding page of our site www.perlesandco.com.
