Learn how to make a beautiful DIY crystal ring with our tutorial, and add a touch of sparkle and sophistication to your jewelry collection. Crystal rings are very much in vogue. They are synonymous with sophistication and elegance. Crystal is very popular for its ability to reflect light and shine. It adds a touch of glamour to any outfit. We have a wide range of crystal beads and cabochons to choose from. From PureCrystal to Aurora to Preciosa, you're spoiled for choice.
The pearl and crystal ring we present in this tutorial is also made of seed beads. To add a touch of fantasy to our jewelry, we took a mix of colors of seed beads. These beads are not very regular which gives the ring an artistic touch. If you want to replace these seed beads, you can also use 8/0 toho seed beads or 3 mm beads with a 1 mm hole. You can find some product suggestions at the bottom of the page.
For this DIY creation, we used elastic wire to make the ring fit well on the finger. You can also try using nylon fishing line if you have it. There is no need for needles for this weave, as it is very simple. You will just need a little patience to get the thread through the beads.
The crystal and pearl ring trend revisits classic jewelry pieces with a modern twist. These accessories work equally well with casual outfits or dressy ensembles, bringing a touch of sparkle and luxury to any occasion. Their growing popularity is a testament to the growing appeal of unique and personalized jewelry, reflecting the history and tastes of the wearer.
Fix the two cabochons shuttles in their crimps. To do this, place the cabochon, hold it in place with your thumb and then fold down one of the crimp claws with a flat clip. Then fold down the second claw, diagonally to the first. Finish with the other two prongs.
Cut 20 cm of elastic thread. For this tutorial, we have selected only the green, white, pink, purple and gold beads in the rockery mix. Thread 4 beads and place them in the center of the thread. Pass through the first bead with the other end of the thread to form a loop as shown in the photo.
Thread a bead on each end of the thread and then thread a new bead and cross the other thread in. Repeat this step until you can go around your finger with the weave - 1.5 cm.
Then thread the crystals by passing the two wires through the holes in the crimps. Double check that the ring is not too big or too small.
Thread 1 bead onto each end of the wire and then cross the two wires inside the very first bead.
Thread the wires through the two beads strung in step 5 and then through the cabochon navette setting. Make a double knot inside the crimp. Put a small amount of glue on the knot and cut the threads 1 mm from the knot. Let the glue dry for 24 hours.
You have a question about this tutorial? Ask it to our team and the people who have already tested it. The Perles & Co community is here to help you!
Credits
Perles & Co, Internet & E-Commerce company [02/04/2023] Any reproduction, representation, adaptation, in any form whatsoever, even partial, is prohibited, except for reproduction for private use not intended for collective use, representation in the family circle (art. L 122-5 CPI) and online publishing on condition that the source is mentioned and a link is included to the corresponding page of our site www.perlesandco.com.
