You want colors and jewelry that will accompany you throughout the summer? We've got just the tutorial you need! In less than 15 minutes and for less than 15€, make a trendy 3-in-1 jewel that can be worn as a necklace, bracelet or anklet. To do this, find the perfect size that will make this jewel your summer ally by adapting to all your desires. With 90cm of chain, this jewel can be worn both as a multi-rank bracelet (about 6 turns of the wrist), as a choker or as an anklet (about 4 turns).
This stainless steel jewel is, as its name suggests, water resistant and can follow you in your daily adventures. Water, salt, sun or acidity from perspiration will not harm it. To learn more about water resistant materials, you can consult our technical sheet: Which jewelry is water resistant? But if, as a precaution, you prefer to remove your jewelry for a swim, a bit of sport or simply to change your jewelry, the T-clasp and its ease of use will allow you to put it on and take it off in no time and without the help of an extra hand (practical, isn't it?)
As for the colors, you have a wide choice. Personalize this jewel with the epoxy resin chain and charms of your choice. We have chosen here a charm with an astrological sign or zodiac sign but there are hundreds of others on the site: charms with letters and numbers, charms with gri-gri or even fancy charms, the choice is yours. At the bottom of the page you will find a selection of chains available in gold and silver.
To make this tutorial, you need very little material: the chain of your choice, a T clasp, a charm and open rings. On the material side, a ruler and a set of 3 jewelry pliers consisting of a flat nose pliers, a cutting pliers and a round tip pliers.
In case you want to make this a 3 in 1 piece of jewelry, take the measurements of your neck, wrist and ankle and find the measurement that is compatible. Here, a length of 90 centimeters of chain allows you to make a two-row necklace, a 6-row bracelet and a 4-row anklet.
At each end of the chain, connect a part of your clasp with a 3mm open round ring. To open your ring correctly with your flat and round tip pliers, see our technical sheet: How to open a ring to make a piece of jewelry?
Finally, connect your round charm to the ring of your clasp with a 5mm open round ring.
You have a question about this tutorial? Ask it to our team and the people who have already tested it. The Perles & Co community is here to help you!
Credits
Perles & Co, Internet & E-Commerce company [31/05/2022] Any reproduction, representation, adaptation, in any form whatsoever, even partial, is prohibited, except for reproduction for private use not intended for collective use, representation in the family circle (art. L 122-5 CPI) and online publishing on condition that the source is mentioned and a link is included to the corresponding page of our site www.perlesandco.com.
