Organza butterfly necklace, Fimo paste and UV resin

How to make jewelry in Fimo clay and resin?

Step 1

Take some white Fimo paste, spread it out with a roller or a baking machine. Choose a fairly fine or medium notch for the thickness of the dough. Put your organza butterfly on the dough and then roll it over to press it down and almost push it down.

2nd step

With the help of a cutter cut out the edge of the butterfly. Lift the butterfly and then with your fingers smooth the too prominent edges of your cut.

Step 3

Scrape off a piece of dry pastel with the cutter to obtain a powder. Pass this powder on the borders either with your index finger or a brush. You can just as well do not do this step and paint with acrylic edges after baking.

Put your butterfly in the oven at 120 degrees for 30 minutes. The fabric will not be damaged!

Step 4

Put a few drops of UV resin on the whole of the straw and then with a toothpick or other small tool spread the resin to the edges. Place the uv led lamp above the paillon press the button twice and wait 60 seconds. Wait two minutes before starting this step again. You can with this lamp use UV LED resin also, both work well.

Step 5

Make sure the surface is dry and not sticky to pierce it. Use a forest of about 1.5 mm with a Dremel drill or a hand mandrel. You can cut a 2-part fabric butterfly to make matching earrings to your necklace using the same principle.

Step 6

Change the rings too small on the choker by replacing them with 5mm rings. Pass them through the butterfly hole and close them with pliers. Pass the same ring in the hole of the earrings then put the ring in the ear stud. Your adornment is over you can have fun making different butterflies, we have all sizes and colors that can be mounted in bracelet, brooch, hairpin.