Miyuki Half Circle Interwoven Choker and Tassel Braid

How to weave Miyuki beads on a weaving spacer?

How to weave Miyuki beads into a weave interlayer?

This tutorial uses an exclusive semi-circle pendant designed internally at Perles and Co. This interlayer can be woven with Miyuki beads and mounted in saltire as in this example or used as a chandelier for earrings to weave.

If you're just starting out and do not know how to weave Brick Stitch beads on a spacer, check out this step by step video: DIY Creation Earrings Creoles Weaving Brickstitch Miyuki Delicas Emerald .

In this tutorial we add pom-poms to the jumper. Many colors exist, you will inevitably find the one that pleases you in our category " Gallons Pompons ".

Step 1 :
Follow the video previously to see how to weave beads on a weave interlayer. Cut 1 m of thread and tie the end to the interlayer leaving 10 cm of thread end. Thread two white pearls, place them at the end of the thread and wedge them against the interlayer, side to side. Pass the needle under the tab bar and return to the second bead threaded. Squeeze and pass in the first then in the second so as to form a loop that will tighten the beads. Thread a new white pearl and attach it to the tab bar also. The first woven row is composed of 20 white pearls.

2nd step :
Weave the second row starting with an increase in Brick Stitch . Alternate white pearls and golden pearls. There are 11 white pearls and 10 gold beads on this row.

Step 3:
Put glue on the back of the tassel braid just before the first tassel and after the fifth tassel. This step will prevent the braid from breaking up when you cut it. Once the glue dries, cut the braid symmetrically and keeping 5 pompons intact.

Step 4:
Place yourself in the second bead of the first row, the wire to the outside of the tab. Go through the pompom braid to sew the weave. Go over the gold part of the braid, step underneath and go back to the third pearl of the first row. Move your needle in the first row to go into the sixth bead and repeat the process to sew the second tassel of the braid. Continue by sewing the third pompom from the tenth pearl, the fourth with the fourteenth pearl and the fifth with the eighteenth. Make a double knot on the back of the pompom and cut the thread.

Note: If, despite the glue, the sides of the tassels break, take a thread and a needle and reattach them together by sewing.

Step 5:
Connect a 70 to 80 cm chain to the pendant with two small rings.