Wrap bracelet in peyote weave with Rocaille Miyuki pearls

How to make a wrap bracelet from peyote weaving?

How to make a wrap bracelet in peyote weave?

How to weave a pair peyote weaving bracelet with glass beads Rocaille Miyuki 8/0?

You want to put a personal touch in your outfits with a DIY woven bracelet. Realize the wrist weave bracelet of Aude aka Butterfly Iodé while discovering the technique of peyote weaving with Rocaille Miyuki 8/0 glass beads.

Before starting your DIY bracelet do not hesitate to go to our toolbox where you learn the basics of peyotepairweaving and in our Rocaille Miyuki 8/0 references to vary the colors.

Thanks to Aude for sharing his tutorial.

Step 1: Prepare your peer peyote weave. Weave peyote 8 columns of Rocaille Miyuki 8/0 with the following indications: 1) Start with one color on 9/10 rows (here black),
2) Then gradually integrate a second color up to 18 rows (here walleye),
3) From there, the second color became majority.
4) Continue to weave with the 2nd color by incorporating a pearl from time to time of the 1st color (up to the 30th rank),
5) From here, only weave the 2nd color on 8 rows,
6) Then gradually integrate the 3rd color (here the white) in 5 rows until it becomes majority,
7) Then weave the final 15 rows with only the 3rd color by incorporating one or two pearls of the 2nd color.

Step 2: Finish your Peyote weave.
Thread the end thread through the beads 2 or 3 rows back and then burn the excess thread.
Do the same with the starting thread.

Step 3: Ride your weaving way wrap.
Cut two 20 cm leather cords, here black.

1) To hang the cord pass the wire in the 1st pearl.
2) Then go back in by integrating the cord.
3) Tighten and tie a knot, keeping a little wire outside, it will be used to finish the assembly.
4) To "wrap" the cord (picture on another model of bracelet) pass the thread in the 2nd pearl (inside to outside).
5) Then go back in by integrating the cord.
6) And then start again until the last pearl.

3) Repeat points 1) and 4) for the lower cord.
4) To finish the seaming of the cords, iron the ends of the threads in the beads in 2 or 3 rows and burn the end of the thread.

Step 4: Finish his wrap bracelet.
Adjust the length of the cords.
Insert the cords into the end caps and glue.
You can finish your bracelet by adding the rings and the clasp.

Solidify the whole by applying a light coat of varnish on the peyote and the seam of the cord, especially at the beginning of weaving and at the end of weaving. (Optional)

Your bracelet is now finished!

We love to see your creations so do not hesitate to send us photos of you loops on our Facebook page or to tag us on Instagram with #Perlesandco !

NB: Attention, the list of products below is not completely in conformity with the picture of presentation. For stock reasons, some products in this tutorial have been replaced by equivalents. The tips, the rings and the clasp have been replaced by other references.