
Realize in a very short time a chic, trendy and colorful necklace. Ideal for the holiday season but also worn on a daily sweater knitted it will brighten your look.
Step 1
Take your two squared claws and drops. Place your cabochons inside then with a flat clip close all the claws that will trap your crystals, you can refer to our explanatory sheet.

2nd step
Take your three crimped, drop a few drops of glue at the bottom and on the edges then push your cabochons.

Step 3
Take five-mm rings, place them by opening them in each ring of the crimped. Hang your crystals in the holes of the golden interlayer, close your rings. Take your two pendants already set to place them at the ends.

Step 4
Take your bead chain, place in a link at one end a ring that you will hang at the leftmost hole of the tab where there is the smallest set.
Place your chain so that it covers all the rings of the spacer. Place a ring in the chain and hang the same ring on the other end of the tab. Cut the excess of chain.

Step 5
Take your neck, open the rings used to place a tab and remove them. Put instead 5mm rings because the ones in the chain are too small.













You have a question about this tutorial? Ask it to our team and the people who have already tested it. The Perles & Co community is here to help you!
Credits
Perles & Co, Internet & E-Commerce company [23/11/2017] Any reproduction, representation, adaptation, in any form whatsoever, even partial, is prohibited, except for reproduction for private use not intended for collective use, representation in the family circle (art. L 122-5 CPI) and online publishing on condition that the source is mentioned and a link is included to the corresponding page of our site www.perlesandco.com.