Summer is over and the autumn wind is starting to settle in. The golden Autumn jewelry collection will be there to comfort you. Trendy creations, with colorful touches that will brighten your days dulled by the cold.
For this easy ring tutorial we chose to create an accumulation of 3 matching rings made of gemstones and golden touches. Thanks to our numerous gemstones available on our website: Amazonite, Amethyst, Rose Quartz, Labradorite, Moonstone... Your compositions will be infinite and certainly very original! Something to dress up your pretty fingers.
You like gemstones jewelry? Find the other tutorials of the golden autumn collection below:
This DIY ring will allow you to accessorize your outfits with a colorful touch. Play with the sizes and colors, alternate and mix and you will know perfectly how to accumulate the pretty rings! Choose the colors you wear the most from our thousands of gemstone beads references.
Start by measuring your fingers. Here we are on a size 9.5, so we will need 22 gold beads and 36 moonstone beads.
Then cut two pieces of wire and stretch them out. Thread the gold beads in the center and the gemstones on each side.
Cross the two pieces of yarn over each other to form a cross.
Choose a bead to crush and thread the four pieces of wire through it. Tighten the wires so that the bead to be crushed is against the gemstone beads and closes the ring well.
Finally, crush the bead with a flat nose pliers. For a cleaner finish, use a crushable bead cover.
Loosen the wire by stretching it. String the beads with a different color in the center.
Close the ring with a surgeon's knot.
Tip: check out our data sheet"How to tie a surgeon's knot?"
For a clean plud finish, put glue on the knot, then use flat pliers to add a pearl cover to crush.
Take the elastic wire and cut about 10 cm for each ring. Loosen the wire by stretching it on each end.
String the beads on the wire, incorporating a different color in the center.
Offset the beads on one side of the wire. You will use the rest of the thread to make your finger ring (without cutting it).
Close this top ring of beads by twisting your two ends together.
Now form your finger tower. You can use a forging tool to help you.
Then twist the end of the wire between the colored beads. This will solodify your ring.
You have a question about this tutorial? Ask it to our team and the people who have already tested it. The Perles & Co community is here to help you!
Credits
Perles & Co, Internet & E-Commerce company [03/10/2022] Any reproduction, representation, adaptation, in any form whatsoever, even partial, is prohibited, except for reproduction for private use not intended for collective use, representation in the family circle (art. L 122-5 CPI) and online publishing on condition that the source is mentioned and a link is included to the corresponding page of our site www.perlesandco.com.
