Among our specific tools, we have
Cut 3 pieces of wire. Bend them and place them behind the tool screws to create the spirals. Screw on without forcing. The space between the two plates is now the same thickness as your wire.
Place the crank in the hole, face down.
Cut your piece of wire. Here, 30 cm. Pass it between the two rods and through the crank slot, without letting it protrude. Make a spiral of about 18 mm.
Remove the crank. Slightly loosen the screws to remove the spiral.
Make a second 15 mm spiral. Hide the end behind the spiral.
Glue to the ear stud tray, then leave to dry for at least 1? hours, with the loop held flat.
Make a second identical spiral. Place the first one behind the tool to check the size.
Form a loop perpendicular to the spiral for hanging. Mount the earring.
You have a question about this tutorial? Ask it to our team and the people who have already tested it. The Perles & Co community is here to help you!
Credits
Perles & Co, Internet & E-Commerce company [22/05/2022] Any reproduction, representation, adaptation, in any form whatsoever, even partial, is prohibited, except for reproduction for private use not intended for collective use, representation in the family circle (art. L 122-5 CPI) and online publishing on condition that the source is mentioned and a link is included to the corresponding page of our site www.perlesandco.com.
