Hiilos Multirang pink and turquoise bracelet with interchangeable clasp

Attach 8 threads to the loom. To do this, do not cut the thread from the spool. Unwind it, attach the end to the nail, pass the thread on the loom, still unwinding the spool. Wrap the thread onto the second nail and return to the first one by installing the second thread. Wrap it around and continue. Then tie the thread with a double knot and cut it.

Cut 1.7 m of weaving thread, tie it to the outer thread of the loom, keeping 20 cm of thread end.

String the first row of beads, go under the weave with the beads and pre-place the 7 beads between the weave threads. 1 bead must be between 2 threads. Pass the needle back through the beads, being careful to pass over the loom threads. Tighten and repeat this step with the second row. The weave will tighten as you go along. By the end of the third row, there will be no real need to tighten.

Follow the pattern. To change the thread when it is only 15 cm long, catch the thread in the weave by passing through the previous rows. Make 3 or 4 passes, trying to go far into the weave. Take a new 1.7 m thread and wedge it in turn in the same way then continue where you left off.

To stop the weave, tie a double knot on the loom thread at the edge of the weave. Catch the thread in the weave. Cut the threads, keeping as much of the thread length as possible. Tuck the threads one by one into the weave. Trim off the excess thread, then pass the first and last rows of beads through the tubes. Close the tab on each side.

The first part is finished.

The second part is composed of 3 braids on which are fixed 3 threads with beads. 1 thread on each braid. To start, tie the end of the ready-made braid with a tight knot. Cut 60 cm of Miyuki or Fireline thread. Thread it onto a needle. Tie the two ends of the yarn with a double knot. Thread the needle through the braid near the knot.

String your beads. If you put a bead in the center, try to center it by measuring the length as you go. The bead wire should be about the same length as the bead weave.

Once the right length is reached, tie a second knot on the braid. Pass the needle through the braid near the second end knot and tie the yarn to the braid with a double knot. Trim the ends of the yarn. Repeat steps 3-5 to get two more sets of braid + bead wire.

Put glue on the knots and slide the knots into the tubes. You can use a toothpick to push the braid and the knot into the tube. Close the two legs of the tube.

Your bracelet is ready! Slide the tubes into the clasp to wear it.