Flower bracelet

Start by taking your measurements depending on whether you want to wear this jewel on your wrists, ankles or around your neck.
Cut a length of wire about 3 or 4 times longer than the measurement you took.

To form flowers with beads,

• String 4 beads of the color of your choice on your thread
• Thread 1 gold bead (or other color) to form the center of the flower
• Pass your thread through the 1st coloured bead (backwards)
• Thread 3 coloured beads again
• Thread through the coloured bead before the gold bead in the centre
• Pull your thread so that the coloured beads are positioned correctly around the golden bead in the centre.

Your first seed bead flower is finished

Make a sliding knot in macramé to put on and take off your bracelet easily.

To do this, tie a thread on both ends of your bracelet and make several flat knots in macramé, about 6 or 7.

To discover in video the technique of the sliding knot in macramé you can see the following tutorial from 5'40: Macramé bracelet beads gemstones sliding knot

Cut the ends of the wires and burn them with a lighter.

For the finishing touches, you can insert two 8/0 seed beads at the ends of your bracelet. Make one or two knots to hold the beads in place.
You can also simply choose to make knots without inserting any beads first.
Cut the wires very short before burning them with a lighter.