To create a multi-row necklace, you have 2 options: either you use a single clasp for all your necklaces, whether it is multi-row or not, or you add a clasp on each necklace. In this tutorial, we have used a multi-row clasp on 3 of the necklaces and the long necklace with sun card pendant has a separate clasp. For the latter, we used a necklace made with the clasp and the extension chain. You can of course create it from scratch thanks to all our fancy jewelry designs.
The Tarot card pendant exists in several models. Find the pendants card moon, star and world in our category golden pendants. Also discover all the products used in this tutorial at the bottom of the page after the steps.
This set of matching necklaces will be perfectly highlighted on a white or black blouse that will bring out the gold of the miyuki spacers and the turquoise of the heishi. A little summer dress will also be perfect.
Don't hesitate to show your creations on our Facebook page, in the Super club group of Perles & Co customers or on Instagram by quoting us with @perlesandco or with the #perlesandco.
In order to add the pendant to the ready-made necklace, you will have to open the ball chain attachment on one side of the necklace. To do this you can use a cutter tip or pliers to open the double rings that you will slide into the slot on the side of the tip to open it. Then slide the pendant onto the chain. Before putting the tip back on, make sure that the length of the necklace fits you, otherwise cut the chain.
Cut a 60 cm nylon thread. Thread a pearl to be crushed on it, then pass through one of the rings of the clasp and iron in the pearl. Crush the pearl with a pearl crusher and fold it in half. Keep about 7 cm of wire.
Thread 10 turquoise howlite tubes and then the following sequence: a golden washer, 8 mm polymer heishi, a golden washer, 3 howlite tubes and repeat the sequence 4 more times. Pass the remaining piece of string through the beads to hide it.
String 3 miyuki triangle spacers, 1 freshwater pearl, then 6 freshwater pearls 4 times before repeating the previous sequences to make a symmetrical necklace. Thread a pearl to be crushed, pass through the ring of the clasp and back into the pearl, then tighten the thread and flatten the pearl to be crushed. Close a squeeze bead cap on each squeeze bead. Slide the remaining piece of wire into the beads for 7 cm before cutting the rest.
Cut a 60 cm wire again and attach it to the clasp in the same way as before. Thread the following string of beads, which you will repeat a total of 8 times, separating them by 3 triangle spacers each time: 10 white bisque delicas, 1 triangle spacer, 5 turquoise delicas, 1 triangle spacer, 1 white bisque delicas, 1 triangle spacer, 5 turquoise delicas, 1 triangle spacer, 10 turquoise delicas. Finish with a squeeze bead and place squeeze bead caps on each squeeze bead.
For the third link, add a 41 cm chain thanks to 1 open ring on each end of the chain. In the centre, add a small gold leaf pendant with another ring.
You have a question about this tutorial? Ask it to our team and the people who have already tested it. The Perles & Co community is here to help you!
Credits
Perles & Co, Internet & E-Commerce company [10/03/2021] Any reproduction, representation, adaptation, in any form whatsoever, even partial, is prohibited, except for reproduction for private use not intended for collective use, representation in the family circle (art. L 122-5 CPI) and online publishing on condition that the source is mentioned and a link is included to the corresponding page of our site www.perlesandco.com.
