Check out these two-part rivets (one male part and one female part) made of gold-plated 304L stainless steel tocustomize your phone cases and handbags!
Thanks to the ring built into a small ball, you can add a DIY phone charm or a handmade bag charm. For inspiration, check out our tutorials!
Create a unique phone lanyard—a super trendy accessory! Simply attach the rivets to the bottom of your phone case, then thread a polyester cord through them. Then add an earring back so you can adjust the length to your liking. To make it look even nicer, glue some end caps onto both ends of your braided cord. And there you go—you can wear your phone strap around your neck, over your shoulder, or as a crossbody strap. No more rummaging through your purse to find your cell phone!
These gold-plated stainless steel rivets are a reliable fastening solution for customizing your cell phones and DIY accessories.
How do you attach a rivet?
1. Mark the spot on the back of the phone case where you’ll attach your phone charm.
2. Pre-drill a hole.
3. Insert the shank from the bottom.
4. Take the rivet cap and screw it onto the shank.
5. Give it a few light taps with a hammer until the two parts snap into place.
This product has been coated with a PVD finish.
Details:
Total height: approximately 16 mm
Height: 9 mm
Width: 8 mm
Ring wire diameter: 1.1 mm
Sold in packs of 2 rivets
