Creoles woven pearls pearl PureCrystal mini hematites

Cut just over 1 m of weaving thread. Make a double knot on the interlayer, leaving at least 10 cm of thread end. Place the thread on a needle, then thread a 3 mm pearly bead, a mini cube, another pearly bead. Pass the thread around the ring and back through the last pearl. Tighten and draw the beads together. If you're unfamiliar with this technique, you can find explanatory diagrams in this tutorial: "Créoles perles Amos® argentées tissage Brick Stitch Miyuki"

You can glue the cabochon at the end of the weaving.

Slip on a mini cube and a new PureCrystal Crystal Dove pearl. Pass the thread around the ring and back into the last pearl. Continue until you have strung 15 3 mm pearls and 14 mini-hacute cube beads.

Thread 7 Miyuki 15/0 seed beads and pass the needle through the juxtaposed mother-of-pearl bead. Pass the thread around the ring and back into the bead. Also pass through the last two rocailles.

Thread 5 seed beads and pass through the next pearly bead. Pass under the ring and back through the bead and the last 2 rocailles. Repeat this operation until you reach the last pearl.

Your needle comes out of the last two rocailles threaded. Now thread 1 mini-hématite rectangle, 1 rocaille bead, 1 4 mm mother-of-pearl bead, 1 rocaille, 1 mini-hématite rectangle and go into the two rocailles beads and the mother-of-pearl bead from the previous tape. Pass back under the ring with the thread and return to the 3 mm mother-of-pearl, the two seed beads and the rectangle bead. Thread in 1 pearly 4 mm bead, 1 seed bead and a new mini-rectangle bead. Hook them onto the weave as before. Continue until you reach the other end of the creacle. Once in the last 3 mm pearly bead, make a double knot with the existing threads, then pass through the pearly bead and several other beads to wedge the thread into the beads, then cut excessively.

To make the weave a little stiffer, you'll thread a metallic thread through the last row of beads. This step is a little tedious and optional. Leave the thread on the spool to avoid it slipping too much when you pull on it. Start with one of the 4 mm mother-of-pearl beads, pass the metallic thread through the seed beads and so on. Finish by passing through the last rectangle bead and the two seed beads. Cut the thread from the spool, leaving a little margin to feed the thread into the other rectangle bead and the rocailles. Wrap the thread of each bead around the existing weaving thread, then trim off the excess.