Miyuki Bugles 3D beaded star himmeli style

You can use 0.10 mm fireline for this tutorial. It will be stronger than miyuki wire. Thread four 6mm flugelhorns, place them 15 cm from the end of the wire and make a double knot with the two ends of the wire to form this diamond.

Pass the needle through a bugle near the knot. Thread a 6 mm bugle and pass through the opposite bugle. This is the second bugle near the knot. The fifth bugle is placed in the middle of the diamond.

Thread 3 x 6 mm bugles. Pass through the bugle where your thread comes out. When you tighten the thread, you form a second diamond.

Put on a 6 mm bugle and pass through the opposite bugle.

Thread 3 more flugelhorns and pass through the flugelhorn again to form a new diamond.

Pass through the next bugle so that the thread comes out in the middle of the diamond and then attach the middle bugle of the diamond. Go around the diamond through the beads to place the needle at the bottom left of the third diamond. Then create the fourth diamond following the same method.

For the fifth and last diamond, you need to connect the fourth and first diamond. To do this, add only two 6mm bugles and pass through the bottom bugle (near the center of the star) of the first diamond. Pass through the bugle near the center of the fourth diamond and attach the middle bugle of the diamond.

Pass through the beads to the center of the star and add 1 seed bead to decorate then pass through the beads again. Tie a double knot using the thread from the weave then hide the thread in the beads and cut it. Also hide the remaining thread in the beads and cut it off.

Create a second identical star, but do not cut the threads of this second star.

Connect the two stars by the point.

Thread a 3 mm bugle and pass through the opposite star while coming down on the next point. Then connect the two points. And so it goes on until you have connected all the points or hollows with a 3 mm bugle. From the fourth point, slide a 10 mm bead of the color of your choice inside. Then close the star all the way to the end. Make a double knot using the thread from the weaving and then hide the thread in the beads and cut it.

Make a double knot using the thread from the weaving then hide the thread in the beads and cut it. Open a ring and slip it into the star from the side. Put the sleeper over the ring and close the ring.