Phone jewel with rivet

Gather all the materials you need. Take advantage of this project to use your bead bag ends of all kinds. Mix colors, shapes of beads to give a unique look.

Cut a length of about 15cm of cabled wire with a pair of wire cutters. Approximately 10cm of ties and 5cm for the finishing touches.

Thread a squeeze bead onto your wire and then run it around your wire guard before running it back through the squeeze bead. Crush it with a pair of flat pliers to seal the two wires that run through it. You can place over the crush bead a crush bead cover through its opening. This allows for a nicer finish.

Once the end of your wire is done, you can start threading the beads. You can either follow the suggested sequence or let your imagination take over.

Use two jewelry clips to assemble your clasp to your link. To do this, open a ring and pass it through the wire guard and into the clasp ring

Here is a possible link variation. Assemble large acrylic links together and connect them with large rings to the clasps.

Using a pair of pliers with a pointed tip or a hand chuck, pierce your phone shell in two places of your choice. Be careful, it must be flexible. A small hole is enough. Then, with a bit of force, place the flat part of the rivet inside your shell. On the top, simply screw the second part of the rivet with the ring. Your phone is ready, you just have to hang your pearl links.