Open a ring and slip the chain and the smallest loop of the eyeglass attachment into it. If you don't know how to open a ring, go to our video datasheet which will show you how. To do this, you need two jewellery pliers.
Cut 45 cm of fishing line. Thread 2 squeeze beads and pass the thread through the thread protector. Pass the thread through the two squeeze beads and pull the thread out 7 cm. Flatten and bend the beads in half with a squeezer.
Thread a gold metal bead. Put glue on the crush beads, then pull the large bead over the crush beads to hide them. Wipe off the excess glue immediately before it dries.
Start threading the beads, beginning with the shells. Thread the two wires through each one until the small end of the wire is hidden. Choose shells, which are lighter than metal and stone beads.
Do the same finishing as in steps 2 and 3.
Connect the shells to the chain with a new ring. Also attach the eyeglass clip to the other side. The shells should face the silicone clip.
You have a question about this tutorial? Ask it to our team and the people who have already tested it. The Perles & Co community is here to help you!
Credits
Perles & Co, Internet & E-Commerce company [05/07/2021] Any reproduction, representation, adaptation, in any form whatsoever, even partial, is prohibited, except for reproduction for private use not intended for collective use, representation in the family circle (art. L 122-5 CPI) and online publishing on condition that the source is mentioned and a link is included to the corresponding page of our site www.perlesandco.com.
