DIY 925 sterling silver macrame and flat beads bracelet

How to make a macramé sliding knot bracelet?

How to make a macrame bracelet with sliding knots?

The saga of special Valentine's Day tutorials continues! We have already offered you some models of men's bracelets to make to offer to your dear and tender ... and we don't stop there! And yes, there is something for everyone.

So this time we suggest you make a macrame bracelet and pearls in 925 silver. We promise, it's very fast, there is nothing complicated. An ideal gift to make with your little hands even at the last minute. A pair of scissors is enough!

Not a fan of khaki? Find our wide range of colors of 1mm linhasita waxed thread on our site. There too, there is something for everyone! You can even, if you feel like mixing the colors together on a single bracelet.

This bracelet can be worn alone or in accumulation with other bracelets, the choice is yours!

For a little extra help, you can take a look at our technical sheet to learn how to make a macrame knot !

Step 1 : Cut 4 x 30 cm of wire. Group them together, and at the upper end, fix the 4 wires on your work support using a piece of tape, or if you have one, on your micro-macrame tray using T-pins .

Step 2 : Insert the 3 925 silver beads at the bottom end. Now also attach the lower end of these 4 wires.

Step 3 : Cut about 1.50m (see more) of wire. Locate the middle and pass the thread under the 4 stretched threads. Make a knot about 8 / 10cm from the top end.

Step 4 : Start weaving around the 4 stretched threads by making a classic macrame knot. Attention, to obtain this twisted / twisted effect you must realize the knot always in the same direction, and not vary the direction of the knot.

Step 5 : When you want, slide the pearl to make your knot around it. Here, on an 18 cm bracelet, the pearls were inserted at 6 cm 9 cm 12 cm. You are free to place the pearls wherever you want. Continue weaving until you reach the desired length. Stop weaving with a double knot and a dot of glue. Cut the wires and burn them.

Step 6 : Once your length is finished, peel off the ends and make them cross. So you get 8 wires. Attach them to the table or your tray and weave classic macrame knots (varying the direction of the knot) over a very short length. This allows the bracelet to slide so that it adapts to all wrists. Stop the threads by making a double knot reinforced with a point of glue. Cut the remaining wires and burn them.

Step 7 : You can group the 4 wires protruding on each side of the sliding knot by a knot.

Here, your bracelet is finished!

Do not hesitate to share with us the result of your creation by posting a photo on our social networks: our Facebook page and our Instagram page