Macramé bracelet with flowers and Alphabet beads

Cut 2 pieces of wire: one 40 cm long and the other 1.2 m long. Place the 40 cm piece on the tray. Tie the 1.2 m piece on the 40 cm piece. You should have 60 cm of thread on both sides of the knot.

Take the 3 m piece of yarn and tie it on the 40 cm yarn, above the previously tied yarn. You should have 1.5 m on each side of the knot. Tie this long thread on the 60 cm thread following the video. You must first go over the 60 cm thread, then under and through the loop formed. Then you must reverse. Go under the 2 foot wire, over and through the loop. Tighten the wire and repeat these two knots 5 times on each side.

Thread the first letter onto the shorter thread. Cross the two 60 cm threads over the centre thread, one of which must go under the centre thread. Follow the video to make the final knot that will bring the circle together. Tighten and pull the two two foot wires together. Then repeat steps 2 and 3 to secure the Alphabet beads together.

Once you have attached all the letters, fill in the empty space if necessary with a macramé overhand knot on each side of the bracelet. Melt the remaining wires except for the center wire and add a touch of glue. You can also use only glue, but in generous doses and cut the wire only after the glue has dried. Make a macramé slip knot to close the bracelet.