Set Earrings and Bracelet with Toho seed beads

To make cuff A and earrings (model C) you will need :
- 4 bags of Seed beads Toho 11/0 TO11R122 - Opaque Luster Navajo White
- 4 bags of Seed beads Toho 11/0 TO11R45F - Opaque Frosted Pepper Red
- 1 clasp
- 1 pair of earrings

To make model B :
- 2 bags of Seed beads Toho 11/0 TO11R122 - Opaque Luster Navajo White
- 2 bags of Seed beads Toho 11/0 TO11R45F - Opaque Frosted Pepper Red
- 102 PureCrystal 4 mm Siam bicones
- 1 clasp

Step 1:
Thread 1 meter of thread through the eye of a needle.
Center the needle and thread a seed bead (leave a few cm of thread available, which will be tucked into the beads at the end of weaving).
Slide the bead to the ends of the thread and tie a knot.

Step 2:
String the number of beads corresponding to the pattern you wish to create, and refer to diagrams 1 and 2.

ATTENTION: Seed beads are woven 2 by 2 or 1 by 1.
1 crystal bead is worth 2 Seed beads.

Clasps or ear hooks are fastened either with back stitches or as follows.
(the operations are identical for clasps or ear hooks) the 2 clasp parts attach to both ends of the bracelets and to the same beads.
Take 10 cm of nylon thread and pass it through the beads indicating the clasp or ear hook attachment.
Center the piece of thread. Thread 1 bead on each of the 2 thread ends.
Pass the thread ends through the ring of one of the two clasp parts or through the ring of an ear hook, then through the bead again and flatten it with flat-nose pliers.

Tips :
To change a thread, keep the equivalent of 20 cm of thread.
Pass the needle through the woven beads.
Pick up a thread and pass your needle through the woven beads again, returning to where you left off.
To make the bracelet fit your wrist, remove or add rows of bicone weave in the middle.
To follow the pattern easily, get a piece of white paper and place it on the starting line.
Each time you complete a row, move the paper one square.