
Step 1 :
Mountain rank, it always turns up with 4 beads as shown below.

Step 2:
Jewel beading Rank



Step 3:
When the rank D is completed, return to A and then repeat B-C-D-A-B-C-D etc... The rounded top and bottom are constructed themselves. The finished jewelry, attach the clasps on each side with some seed beads. Then stop the thread circulating in the beads.
Step 4:
Then take an other thread. Block it to one end of the jewel in the circulating beads. Put the collar flat and then pass the thread through all groups with 2 seed beads on the collar edge (in red in the diagram above), pressing gently. This passage, invisible, slightly tighten the neck and prevent it to gondol. You will block the thread to the other end of the necklace also circulating in the beads.
Here the same necklace with differents colours :












You have a question about this tutorial? Ask it to our team and the people who have already tested it. The Perles & Co community is here to help you!
Credits
Perles & Co, Internet & E-Commerce company [05/01/2016] Any reproduction, representation, adaptation, in any form whatsoever, even partial, is prohibited, except for reproduction for private use not intended for collective use, representation in the family circle (art. L 122-5 CPI) and online publishing on condition that the source is mentioned and a link is included to the corresponding page of our site www.perlesandco.com.