Come
With a permanent marker, note the center of the gemstone vote.
Put on the diamond drill, start with speed 1 of the Dremel, hold your stone firmly in the water. And drill the Labradorite. The video was shortened, but this part is much longer.
Be careful with your fingers.
Check the length of the stem and then cut it with a pair of wire cutters. If it is too long, drill your stone again. The cabochon holder must be perfectly plated to your gemstone.
Use the paste to visualize your creation and position your elements on the stone. Make a mark with a marker and pre-drill. Then glue the different elements on the stone
To finish, simply attach your open ring to your pendant and chain. Add the lobster clasp and your necklace is complete.
-.jpg "How to solder gold filled (rolled gold)?")
-.jpg "How to make an emerger (a fly)?")
Credits
Perles & Co, Internet & E-Commerce company [27/02/2022] Any reproduction, representation, adaptation, in any form whatsoever, even partial, is prohibited, except for reproduction for private use not intended for collective use, representation in the family circle (art. L 122-5 CPI) and online publishing on condition that the source is mentioned and a link is included to the corresponding page of our site www.perlesandco.com.
