If you are looking for a new weaving bracelet with 3 mm crystal spinners, you are in the right place! Here is a beaded jewellerytutorial made with Preciosa crystal spinning tops and Miyuki seed beads . These beads are available in many different colours on our website, so you can personalise your bracelet as you wish. The spinning tops can also be replaced by other beads of 3 mm in diameter. Just make sure that the hole size of the beads is similar.
This tutorial is quite simple to make and is accessible to beginners. You can either follow the video and make a beaded spacer that you connect to chains and a clasp, or, if you have a little more experience in weaving, you can also make a bracelet entirely out of beads by repeating the pattern several times. You can also make it in several rows.
This little original bracelet will be perfect for the summer. The sun will perfectly highlight the beautiful reflections of the crystal spinning tops.
We are waiting to see your version of this bracelet so don't hesitate to share it as a review of this tutorial, on instagram by tagging us with @perlesandco or by posting it on the Perles and co Super customers Facebook group.
Cut 1.5 m of thread, thread it onto a weaving needle and then thread 4 rocailles 15/0. Turn in the first rocailles so as to form a loop.
Between each 15/0 bead, add an 11/0 seed bead. Finish the trick by passing through the first 11/0 seed bead strung.
Add one each 11/0 pearl, a 15/0 gold pearl, a 3 mm Preciosa spinner or another type of 3 mm pearl according to your preference and a 15/0 gold seed bead. Go back through the beads to come out at the level of a spinning top.
The thread comes out of one of the spinning tops. Thread 3 beads 15/0: 1 gold, 1 coloured, 1 gold. Return to the spinning top through the hole opposite the one from which the thread comes out. Pass through the gold and coloured beads again.
Thread 3 coloured 15/0 seed beads through the first seed bead to form a loop. As in step 2, thread an 11/0 seed bead between each 15/0. Then the spinners and the golden beads between each 11/0. Then place yourself in the spinner where you will continue weaving and repeat steps 4 and 5 to have a third set of beads. You can repeat these as many times as you like to make a whole bracelet.
Once the third part is woven, make the outline of the bracelet by adding between each spinning top from the outside, 1 pearl 15/0 gold, 1 pearl 15/0 coloured, 1 seed bead 11/0, 1 pearl 15/0 coloured, 1 pearl 15/0 gold.
Then make a new turn by adding on both sides, above the spinning tops by passing in the golden rocks which border them, 4 golden 15/0 rocks, pass the needle in the last link of the chain and go in the golden rock of opposite. Adjust the length of the chain before adding the other side. Iron a total of two times around the edge of the bracelet before cutting the thread. Iron the remaining thread through the beads as well before cutting.
Cut the chain in half in the middle. Add the clasp on one side and a ring on the other.
You have a question about this tutorial? Ask it to our team and the people who have already tested it. The Perles & Co community is here to help you!
Credits
Perles & Co, Internet & E-Commerce company [13/06/2021] Any reproduction, representation, adaptation, in any form whatsoever, even partial, is prohibited, except for reproduction for private use not intended for collective use, representation in the family circle (art. L 122-5 CPI) and online publishing on condition that the source is mentioned and a link is included to the corresponding page of our site www.perlesandco.com.
