Miyuki pearl bracelet with Chill out message

How to weave Miyuki delicas bead letters?

How to weave letters in Miyuki delicas beads?

Today, back on a beach and summer classic: Pearl message bracelets! There are in the form of tapes to tie directly to the wrist but also with seed beads or beads Miyuki delica. We have decided to offer you a small alphabet to help you get a message across your wrist. Find our example of bracelet with marked "Chill out" relax in English after the alphabet grid in Miyuki delicas .

To make it easier to put on and tighten the bracelet yourself, the finish is a macrame sliding knot . To be able to make this finish you will have to slightly extend the thread on each side of the weaving by wrapping it around the wooden logs of the loom at least 3 times because you will then have to tie the braided threads at the end. You will then fix in macramé flat knot with a new thread on the crossed braids.

If you are concerned about this method of lengthening the threads of the loom, you can watch the video of the tutorial linked above, which uses the same technique.

Step 1 :
Attach the Ko wire to the nail and wrap the wire around the log 3 to 4 times. Pass the thread through the spring to the other side of the loom then wrap the thread 3 to 4 times around the log again before wrapping it around the nail then another 3 times around the log, iron it other side and wrap the wire 3 times around the log before surrounding it around the nail repeat the operation until you have fixed 9 wires. Take the C-lon beading cord and fix it in the same way on each side. So you have 11 sons.

2nd step :
Weave the bracelet, trying to center it as much as possible on the loom. You can extend the pattern if the bracelet is not large enough. In the state it is 13 cm to which you will add 0.7 cm x 2 for the tips. To weave a bracelet on a loom, cut 2 m of thread, tie it on one of the end threads. Thread the 10 beads of the first row following the diagram, pass the thread with the beads under the threads attached to the loom and place each pearl between two threads. Iron the needle through the beads over the looms. Tighten. Continue until you have woven the entire bracelet. To change the thread, tie it to the weaving and pass it through the beads to hide it. Tie a new thread and hide the end of the thread in the same way before resuming weaving.

Step 3:
For the tips, thread 2 less pearls each time. Center them and weave them normally by winding the outer threads to tighten them against the beads. You will have to pass twice each time. Tie the thread and hide it in the beads.

Step 4:
Cut the wires at the nail.

Step 5:
Tie them in a single braid on each side. Tie a knot to keep them from coming apart. Cross the braids and tie a new piece of C-lon beading cord of 20 cm on the two braids at the same time. Make a flat macrame knot. On 0.8 cm, cut the wires and burn them to prevent the knot from coming loose. Readjust the length of the braids if necessary.

Your bracelet is finished! Do not hesitate to wear it in stacking with weekly gold filled bracelets or other small bracelets.

Do not hesitate to show your creations on our Facebook page, in the Super club group of Perles & Co customers or on Instagram by quoting us with @perlesandco or with #perlesandco.