Miyuki Half Tila beads and beaded beads bracelet

How to weave Miyuki Tila beads?

How to weave pearls Miyuki half tilas?

How to make a bracelet cuffs 3 chevrons?

A highly requested DIY jewelry tutorial is one to learn how to weaveMiyuki Half Tila pearlsat an angle to make a bracelet , necklace or ring . Mariette Bessac proposes today to realize one himself by following his step-by-step .

Thank you Mariette for sharing.

Step 1

Thread a pearl of a recognizable color and block it by making a simple knot or simply by passing the thread twice in it.

2nd step

Prepare the pearls. We need rockeries Miyuki 15/0 and Half Tila. I use Fireline braid 0.12 mm (6LB / 6.8 kg).

Step 3

Thread 1 rockery then 1 Half Tila, 3 rockeries, 1 Half Tila, 3 rockeries, 1 Half Tila and 3 rockeries.

Step 4

Pass the needle through the free hole of the last Half Tila. This will form the edge.

Step 5

Do not over-tighten rockeries and Half Tilas against the original bead.

Thread 1 seed and 1 Half Tila.

Step 6

Pass the needle through the next seed and the free hole of the next Half Tila bead.

Step 7

Thread 1 seed and 1 Half Tila.

Step 8

Pass the needle as in step 6.

Step 9

Thread 1 seed and 1 Half Tila.

Step 10

Pass the needle in the very first rockery.

Step 11

You will get a weird caterpillar, that's normal.

Step 12

Flip your caterpillar and put on 2 seed beads.

Step 13

Thread 1 seed and 1 Half Tila. It does not look like anything but it's normal. This is where it gets a little bit.

Step 14

Pass the needle in the next rockery but NOT in the next Half Tila. Aim at the one who is right after and who has a free hole.

Step 15

Thread 1 seed and 1 Half Tila.

Step 16

Pass the needle as in step 14.

Step 17

Thread 1 rock and 1 Half Tila then pass the needle in the rock alone to the edge.

Step 18

Shoot the starting bead to tighten the first row ... and everything is set up.

Step 19

Flip your first 3 rows. Thread 1 seed and 1 Half Tila.

Step 20

Pass the needle through the rockery and into the next Half Tila.

Step 21

Thread 1 seed and 1 Half Tila then pass the needle through the rockery and the next Half Tila.

Step 22

Thread 1 rock and 1 Half Tila then pass the needle in the next rock (all alone).

Step 23

Then repeat steps 18 to 22 until you reach the desired length, depending on your choker or wrist, or finger.

We can start like this tutorial, with 3 Half Tila beads on each row, but we can also put a single pearl, or two, or five or ten. Here are some examples :

Half Tila Half Tila Bead and Half Tila Bead Necklace

3 beads necklace, 4 beads bracelet and 2 beads ring Half Tila Magic Blue

End of the collar to put the tip in place.

Ring 2 pearls and bracelet 4 pearls Half Tila.

We love to see your creations, so do not hesitate to send us your photos on our Facebook page or to tag us on Instagram with #perlesandco !