These brass claw tips are coated with a gold finish.
1 side with claws and the other without for a better finish.
Use these jewelry primers to create DIY costume jewelry: for example, you can insert several cords, a Liberty fabric bias or a 10 mm wide ribbon. You'll need flat jewelry pliers with a nylon tip to close this component without marking the metal.
We recommend using a Hasulith-type glue dot for added safety. When using thin ribbon or bias, remember to fold it over itself by 0.5 cm. This little trick gives extra thickness and enables the tip to grip the ribbon securely.
The internal diameter of the tip attachment is 1.4 mm, so we advise you to use open rings with a maximum wire diameter of 1.4 mm.
If you're a beginner, have a look at our data sheet to learn how to use a clamping attachment. In this category, you'll find tips and advice on how to start assembling costume jewelry.
Bits sold in packs of 4.













