Brass serrated ribbon crimp ends covered with a golden finish.
These metal jewelery accessory is made in Europe, thus guaranteeing you excellent quality!
These tips will allow you to make a trendy DIY bracelet. They are used with a nylon flat-nose pliers and are perfectly adapted to receive several cords or a 20 mm wide ribbon.
Practical information: we advise you to use Hasulith type glue to fix your ribbon.
When using a ribbon or a rather fine bias, consider folding it back on itself for 0.5 cm and then insert it into the ribbon crimp ends.
This little trick gives a thick additional and thus allows the crimp end to hang on to the tape.
The inner diameter of the holder/loop of the crimp end is 1.4 mm, therefore we advise to use jumprings open with a wire diameter of 1.4 mm or less.
To help you, we have made a technical sheet to show you how to use a ribbon crimp end.
Have a look at our online tutorials to get inspiration.
If you are a beginner, we give you tips and tricks to learn the basics of creating DIY costume jewelry.
Ribbon crimp ends sold by 2.
