Red earrings with soutache and PureCrystal Rivoli Round stone

Step 1:
Cut 4 pieces to Soutache, each with about 12 cm length.

Insert the Soutachebänder around the Rivoli-Cabochon.

Step 2:
Take a thread and tie a knot. Start now with the sewing. Make sure to maintain the round shape of cabochons by make with the needle small, invisible stitches.
Tip: You prick exactly in the middle of Soutache, so you can not see the thread.

Step 3:
When you reach the other side, connect both sides with several pricks from left to right and from right back to left. Thereby tighten thread well.

Step 4:
Take a  4 mm Bicone.

Step 5:
Fix the Bicone by pierce the thread at least twice.

Step 6:
Are you working on a paper page. Thread on a seed bead. Insert the Soutache spirally around the Seed bead and sew accordingly.

Step 7:
Fix the coil carefully on the back.

Step 8:
Cut the excess of Soutache on the back off and tie a knot before you cut the thread.
Proceed in the same way with the other side. Cut the thread. The first element is completed.

Step 9:
Thread a new thread to the needle and tie a knot before you begin as follows.

Cut 3  Soutache pieces, each with about 10 cm length. Place these Soutache, as shown in the photo. Prick with a needle from the inside of the first element to the outside. Connect the two Soutache elements by each sew a 3 mm bicone between the elements, until the desired result is achieved. 

Step 10
Stand out with the needle from the center of the element and thread as follows: a 3 mm Bicone that faceted pearl and 1 seed bead.
Thread back again by the ground glass bead and bicone. Sewing the thread carefully on the back and cut it off.

Step 11:
It continues with a new thread. Insert the needle through the work, as shown in the photo.

Step 12:

Thread 3 Super Duo and insert on the other side (see photo) again. 

Step 13:
Thread a seed bead between each SuperDuo.

Repeat these steps on the other side. The trailer should look like this:: 

Step 14:
Turn your work and apply glue on the cabochon back on.
Allow the glue to dry thoroughly.

Step 15:

Put your ear tag on a piece Ultra-Suede. Transfer the outline of the central part with a pen on the Ultra-Suede. The cut in the form of ultra-Suede is now glued to the back of the trailer. 

Step 16:

Now thread the strap for the earhook.
Insert the needle as in the photo by the work. Thread on 5 seedbeads and attach them to an eyelet. Sewing the thread carefully before you cut it.

Now you only need to customize the second earring!