Precisely round your fine wires with this Maillefer 0.8 mm steel bell cutter, to be mounted on a Dremel for fast, even work.
This 0.8 mm diameter Maillefer steel ball-end file is specially designed to round off and smooth the ends of fine metal wires after cutting. It removes sharp edges that could snag or cause injury, while providing a clean, professional finish to your creations. Its 0.8 mm diameter is perfectly suited for the fine wires used in costume jewelry. You can use it on a rotary tool such as a Dremel to achieve faster, more consistent rotation—ideal for batch production or repeated finishing tasks.
What can you do with this bell-shaped cutter?
For DIY projects, this cutter is ideal for preparing the ends of wires and rods intended for earrings, open bangles, wire rings, or minimalist pendants. It’s particularly well-suited for metal wires, such as brass wire, which is widely used for wire-wrapping projects or delicate structures. By carefully rounding off each end, you improve comfort when worn and enhance the perceived quality of your jewelry. This tool quickly becomes indispensable for achieving clean finishes on minimalist designs where every detail matters.
Size Selection Tip:
For best results, choose a drill bit with a diameter 0.3 to 0.4 mm larger than that of your wire.
Example: For a 0.8 mm wire, choose a 1.2 mm burr.
A burr the same size as the wire will prevent it from entering the bell. A burr that is too large will cause the tool to slip and may deform the wire.
Whether you’re a beginner or an experienced designer, you’ll find tutorials and technical guides on our website to help you work with metal wire. Practical advice and tips will help you choose the right tools, master finishing techniques, and achieve a neat, long-lasting result.
Details:
Length: approximately 44.5 mm
Head diameter: 0.8 mm
Shaft diameter: 2.3 mm
Sold per 1 piece



















