Cotton Buffs for variable speed lathe 100 x 15 mm x1

Polishing Cotton Buffs.
100 mm in diameter and 15 mm thick; sewn on 2 lines.

Use this polishing pad for a shiny finish on your metal creations.

The surface to be polished must be prepared beforehand.
Start with the largest grain and finish with the finest.

Very important, you have to cross the passages, otherwise you will leave too deep traces in the metal!

Screw the polishing disc onto the pigtail of the Lathe, pushing it in about 1 cm. This is sufficient since the rotation of the pigtail will tend to tighten it.
It is normal that during the first uses the disc frays throwing small pieces of wire. It will stabilize after a few uses.
Apply the polishing paste gradually so as not to saturate the fabric.
Use a rigid base for the polishing of the chains (end of wood, thin plank ...).

Sold per piece.